Table of Contents
Advertisement
LIGHTING AND SHUT-DOWN INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around
the appliance for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone in your building.
LIGHTING INSTRUCTIONS
1. STOP! read the safety information
above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the
appliance.
4. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
"GREEN LIGHTED" MAIN POWER SWITCH
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
Figure 26. Lighting Instruction Label
Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
If you cannot reach your gas
supplier, call the fire department.
C. Turn off main power to the water
heater.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been
under water.
5. Turn off the main power switch.
6. Wait (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow
"B" in the safety information above
on this label if you don't smell gas,
go to next step.
7. Turn on main power.
8. Set the thermostat to desired setting.
TEMPERATURE UP
TEMPERATURE DOWN
2. Turn off the main power switch.
39
Advertisement
Table of Contents
