Loudspeaker Dante Channels; Using The Dante Inputs; Using The Dante Output; Routing Signals To The Loudspeaker - Shure Microflex MXN5-C User Manual

• Receive real-time alerts about critical issues, such as low batteries or missing transmitters
• Control access to devices with user profiles
Learn more at shure.com.

Loudspeaker Dante Channels

The loudspeaker has 2 Dante input channels and 1 Dante output channel.

Using the Dante Inputs

The 2 Dante input channels are summed and sent to the loudspeaker's output. These input channels are useful if you need to
send a far-end signal and program audio to the loudspeaker.

Using the Dante Output

The Dante output is useful if you need to send the loudspeaker's signal to another loudspeaker or to an AEC reference chan­
nel. There are 2 processing options for Dante output signal:
Pre-DSP
Sends a pre-DSP signal to the Dante output (DSP is still applied to loudspeaker output). Use this option to send the signal to
another loudspeaker. This option prevents DSP blocks from stacking on top of each other.
Post-DSP
Sends a post-DSP signal to the Dante output. Use this option to send the loudspeaker's signal to an AEC reference channel on
an MXA910.

Routing Signals to the Loudspeaker

To route audio to the loudspeakers, you can use Shure Designer software or Dante Controller software.
1. In Designer, create a location that has all loudspeakers and any Dante audio sources.
◦ Shure's P300 or ANI processors are easy ways to manage Dante signals from many sources.
2. Go to Routing. Drag and drop from the audio source output to the loudspeaker input to create Dante routes.
If you're sending a signal from one loudspeaker to another, use a pre-DSP signal.
Shure Incorporated
13/24