Reset Button; Loudspeaker Dante Channels; Dante Input Channels; Dante Output Channel - Shure Microflex MXN5-C Manual

Networked ceiling loudspeaker
Hide thumbs Also See for Microflex MXN5-C:
Table of Contents

Advertisement

Reset Button

To access the reset button, remove the grille.
There are 2 hardware reset options:
Network reset (press button for 4-8 seconds)
Resets all Shure control and audio network IP settings to factory defaults. Power LED flashes green.
Full factory reset (press button for longer than 8 seconds)
Resets all network and Designer settings to the factory defaults. Power LED flashes green, then solid green after 8 sec-
onds.

Loudspeaker Dante Channels

The loudspeaker has 2 Dante input channels and 1 Dante output channel.

Dante Input Channels

The 2 Dante input channels are summed and sent to the loudspeaker's output. These input channels are useful if you need to
send a far-end signal and program audio to the loudspeaker.

Dante Output Channel

The Dante output is useful if you need to send the loudspeaker's signal to another loudspeaker or to an AEC reference chan-
nel. There are 2 processing options for the Dante output signal:
Pre-DSP
Sends a pre-DSP signal to the Dante output (DSP is still applied to loudspeaker output). Use this option to send the signal to
another loudspeaker. This option prevents DSP blocks from stacking on top of each other.
Post-DSP
Shure Incorporated
11/25

Advertisement

Table of Contents
loading

Table of Contents