Rule Configuration With The User-Defined Service; Figure 80 Bandwidth Management Rule Configuration: Pre-Defined Service; Table 59 Bandwidth Management Rule Configuration: Pre-Defined Service - ZyXEL Communications ZyXEL NBG334SH User Manual

Figure 80 Bandwidth Management Rule Configuration: Pre-defined Service

The following table describes the labels in this screen.

Table 59 Bandwidth Management Rule Configuration: Pre-defined Service

LABEL
#
Enable
Direction
Bandwidth
Destination Port
Source Port
Protocol
OK
Cancel

14.9.2 Rule Configuration with the User-defined Service

In addition to the pre-defined services, if you want to edit a bandwidth management rule for
other applications and/or subnets, click the Edit icon in the User-defined Service table of the
Advanced screen. The following screen displays.
ZyXEL NBG-334SH User's Guide
DESCRIPTION
This is the number of an individual bandwidth management rule.
Select an interface's check box to enable bandwidth management on that
interface.
These read-only labels represent the physical interfaces. Bandwidth
management applies to all traffic flowing out of the router through the interface,
regardless of the traffic's source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the
ZyXEL Device and be managed by bandwidth management.
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
This is the port number of the destination. See
common services and port numbers.
This is the port number of the source. See
common services and port numbers.
This is the protocol (TCP or UDP) used for the service.
Click OK to save your customized settings.
Click Cancel to exit this screen without saving.
Chapter 14 Bandwidth Management
Table 55 on page 140
Table 55 on page 140 for some
for some
145