P782M G.SHDSL Bridge
Step 1.
In menu 11.1, make sure the Edit Bridge field is set to Yes and then press [ENTER] to display
Menu 11.3 — Remote Node Network Layer Options (shown next).
The next table shows you how to configure remote node network layer options.
Table 4-3 TCP/IP-related Fields in Menu 11.1 — Remote Node Profile
FIELD
Ethernet Addr
Timeout
(min.)
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.3
Remote Node Filter
In menu 11.1, make sure the Edit Filter Sets field is set to Yes and then press [ENTER] to display Menu
11.5 — Remote Node Filter (shown next).
4-6
Menu 11.3 - Remote Node Network Layer Options
Ethernet Addr Timeout(min)= 0
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-4 Remote Node Network Layer Options
Type the time (in minutes) for the Prestige to retain the Ethernet
Address information in its internal tables while the line is down. If this
information is retained, your Prestige will not have to recompile the
tables when the line comes back up.
Menu 11.5 - Remote Node Filter
Input Filter Sets:
Output Filter Sets:
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-5 Menu 11.5 — Remote Node Filter
DESCRIPTION
device filters=
device filters=
EXAMPLE
10
Remote Node Configuration