When Required - Takeuchi TL220 Operator's Manual

MAINTENANCE
When Required
Replacing the Bucket or
Attachment
AwARNING
• Read the manufacturer's instructions
manual for attachments not included in
this manual. DO NOT use attachments
that are not approved by Takeuchi.
• Before performing maintenance or
repairs under the machine, set all
working equipment against the ground
or in the lowermost position.
Installation
IMPORTANT: Before installing a bucket
or attachment, make sure the mounting
area of the bucket (1) and the quick-hitch
(3) are clean.
1. Make sure the quick-hitch (3) lock levers
(2) are in the unlocked position.
2. While sitting in the operator's seat with the
safety bar down, start the engine and tilt
the quick-hitch (3) forward.
150
T9G010
3. Move the machine slowly forward and
raise the loader lift arms. The wedge-
shaped top edge of the quick-hitch (3)
must engage in the upper mounts of the
bucket or attachment.
T9G011
4. Roll the quick-hitch (3) back while lifting
the bucket or attachment off the ground.
The quick-hitch (3) will slide into position .
5. Lower the bucket or attachment until it is
25 to 50 mm (1 to 2 in.) off the ground.
6. Stop the engine and raise the safety bar.
7. Push both quick-hitch (3) lock levers (2)
down, securing the bucket or attachment
in position .