After First 50 Hours (New Machines Only) - Takeuchi TL220 Operator's Manual

MAINTENANCE
After First 50 Hours (New Machines Only)
Replacing the Hydraulic Oil
Return Filter
AwARNING
• Stop the engine and allow the
machine to cool before performing
maintenance.
• The engine, hydraulic lines and many
other parts of the machine are hot
directly after the engine is stopped.
Touching these parts will cause
burns.
• The hydraulic fluid is also hot and
under high pressure.
Be careful when loosening caps and
plugs. Working on the machine under
these conditions could result in burns
or injuries due to hot oil spraying
out.
• Oil may spray out if caps or filters are
removed or pipes disconnected before
releasing the pressure in the hydraulic
system.
• When removing plugs or screws or
disconnecting hoses, stand to the
side and loosen slowly, to gradually
release the internal pressure before
removing.
1 . Loosen the bolts and remove the cover
(3).
124
2. Loosen the bolts and remove the flange
(4).
3. Remove the return filter (5).
4. Install the new return filter.
5. Install the flange (4).
6. Inspect the level with the sight gauge (2),
and replenish if the level is low.
Refer to page 121, "Inspecting the
Hydraulic Oil Level and Replenishing."