Start, Stop, And Inactivity Time Out; Power Save Mode (Inactive) - Toro Pro Force 44553 Operator's Manual

Note: If the S
TART
seconds after pressing the R
any other button is pressed in this period, the Engine
Start Enable Condition expires
Note: Engine Start Enable Condition persists for
10 seconds after pressing the R
allowing momentary activation of Engine Start by
pressing the S
TART
does not extend this time period—the maximum length
of time that the Start Relay Control can be active is
10 seconds from pressing the R
After the Engine Start Enable Condition expires, the
Engine Start Enable Sequence must be performed
again in order to energize the Start Relay Control with
the S button. This cannot be performed for 10
TART
seconds after the S
TART
Note: If the sequence is aborted or the Engine Start
Enable Condition expires, normal functionality of the
R R and R
OTATE IGHT
control the Chute Motor.
Important: Do not engage starter for more than
10 seconds at a time. If engine fails to start allow
10 second cool-down period between attempts.
Failure to follow these instructions can burn out
starter motor.
5. After the engine starts, move the choke control to the
O position. If the engine stalls or hesitates, move
FF
the choke back to the O
then set the engine speed to the desired setting. Repeat
this as required.
Stopping the Engine
1. Decrease the engine speed to 3/4 throttle.
2. Press the S button on the remote control.
TOP
3. If leaving the machine, rotate the key to the O
position and remove it from the engine
Start, Stop, and Inactivity Time
out
The remote control activates (powers up) when any push
button is pressed. To conserve battery power, the remote
control stays active for approximately 3 seconds before
automatically shutting down unless there is button activity
within the 3 second limit. When the unit times out and
powers down, all remote control LED activity stops
17). Pressing any button will reactivate the remote control
button is not pressed within 10
R button, or
OTATE IGHT
R
OTATE IGHT
button. Pressing the S
TART
R
OTATE IGHT
button is released.
L buttons return to
OTATE EFT
position for a few seconds,
N
(Figure
button
button
button.
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start

Power Save Mode (inactive)

The RF2CAN and TEC2403 controllers will revert to Power
Save Mode ― until a power cycle occurs ― if the base unit
is inactive for more than 2.5 hours without communication
from the remote control. Power Save Mode is a low current
state of the base unit. In Power Save Mode, the base unit will
not communicate with the remote control, will not activate
outputs, and will not generally function as normal.
•
When in the time-out mode the engine will not run (or
will quit running) and the remote control will not control
any function.
•
To wake controller in time-out mode, turn the key switch
to the O
FF
R position.
UN
•
To avoid controller time-out during operation, use the
FF
remote control to rotate the chute or change the engine
15).
speed at least every 2.5 hours.
(Figure
15
Figure 17
5. Rotate right
6. Increase engine speed
7. Engine stop
position and then turn the key switch to the