Start, Stop, And Inactivity Time Out - Toro Pro Force 44553 Operator's Manual

Note:
If any button other than the next
appropriate button in the sequence is pressed
the sequence is aborted.
Note:
If the S
TART
10 seconds after pressing the R
button, or any other button is pressed in this
period, the Engine Start Enable Condition
expires
Note:
Engine Start Enable Condition persists
for 10 seconds after pressing the R
button allowing momentary activation of Engine
Start by pressing the S
the S button does not extend this time
TART
period—the maximum length of time that the
Start Relay Control can be active is 10 seconds
from pressing the R
the Engine Start Enable Condition expires,
the Engine Start Enable Sequence must be
performed again in order to energize the Start
Relay Control with the S
cannot be performed for 10 seconds after the
S button is released.
TART
Note:
If the sequence is aborted or the
Engine Start Enable Condition expires, normal
functionality of the R
L buttons return to control the Chute Motor.
EFT
Important:
Do not engage starter for more
than 10 seconds at a time. If engine fails
to start allow 10 second cool-down period
between attempts. Failure to follow these
instructions can burn out starter motor.
4. After the engine starts, move the choke control to
the O position. If the engine stalls or hesitates,
FF
move the choke back to the O
few seconds, then set the engine speed to the
desired setting. Repeat this as required.
Shutting Off the Engine
1. Decrease the engine speed to 3/4 throttle.
2. Press the S button on the remote control.
TOP
3. If leaving the machine, rotate the key to the O
position and remove it from the ignition switch
(Figure 14).
button is not pressed within
R
OTATE IGHT
R
OTATE
button. Pressing
TART
R button. After
OTATE IGHT
button. This
TART
R and R
OTATE IGHT OTATE
position for a
N
Start, Stop, and Inactivity
Time Out
The remote control activates (powers up) when any
push button is pressed. To conserve battery power,
the remote control stays active for approximately 3
seconds before automatically shutting down unless
there is button activity within the 3 second limit. When
the unit times out and powers down, all remote control
LED activity stops
IGHT
will reactivate the remote control
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
FF
16
(Figure 16). Pressing any button
Figure 16
5. Rotate right
6. Increase engine speed
7. Engine stop
g029818