Table of Contents
Advertisement
• From normal time display, press and release the SEARCH button to search for the
WWVB time signal.
• Please be sure you have selected your time zone from the list in the Settings menu.
• When the Atomic time signal is received, the station will set to the time zone selected.
Default is Eastern Time.
For best signal reception, follow these steps:
1. Check for a Tower Icon showing on the display near the time. The tower icon indicates
successful reception of the WWVB signal in the past 24-hours.
2. Check that your station is in the correct Time Zone.
3. This station offers seven time zones listed in letter format (default is EASTERN):
4. Check that ATOMIC is ON. This must be ON to receive a WWVB signal.
5. Check that the DST indicator is ON or OFF. If the indicator is OFF your station will not
change into or out of Daylight Saving Time.
6. Batteries dated earlier than 6 years from now may still work, but may be unstable in
performance.
Note: Without proper batteries, the antenna will have a harder time picking up
the signal.
For information about WWVB visit:
• The letters DST below the Atomic Tower icon will show when observing Daylight
Saving Time and disappear when observing Standard time.
• When DST is on, time will adjust automatically if DST ON is selected (default).
• Press and release the SET/MODE button to toggle between full weekday and 3 letter
weekday, month and date.
La Crosse Technology, Ltd.
http://bit.ly/AtomicTime
DST LETTERS DISPLAYED
WEEKDAY | DATE DISPLAY
Page 8
Advertisement
Table of Contents
