• Hold the SEARCH button for 3 seconds to search for all three sensors.
• The lines below each channel number will flash while searching (up to 3 minutes).
• The station will search for missing sensors for 3 minutes every hour.
• The lines will be solid when the sensor is connected.
• If a sensor for a certain channel is not found, the lines below the channel indicator will
not show.
Distance/Resistance
•
window, tree etc., between the display and your sensor. UV coated windows may
actually reflect the signal. Stucco walls will absorb the signal.
• Check batteries. This is our primary warranty issue.
• Test a new set of Alkaline batteries. Write down the date of installation and the voltage
of the batteries.
• When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.
• Check the distance and resistance between your sensor and Weather station. Sensors
at the end of the range may work while batteries are fresh but not after they drain a bit.
• Check for leaking batteries, which may damage your sensor.
HUMIDITY SHOWS DASHES, OR HI | LO BUT TEMPERATURE WORKS
• The humidity low range is 10% RH. If your local humidity is below 10% you will see this
reading.
• Complete a restart with fresh batteries.
• Replace your sensor.
Enter the program menu to select in Fahrenheit (ºF) or Celsius (ºC).
DAILY HI | LO TEMPERATURE/HUMIDITY RECORDS
All HI/LO temperature/humidity records reset automatically at 12:00 (midnight).
•
Press the +/HI button to view indoor and outdoor HI temperature/humidity records for
•
all three sensors.
Press the -/LO button to view indoor and outdoor LO temperature/humidity records for
•
all three sensors
SENSOR AREA IS BLANK (NO DASHES OR NUMBERS)
• Check that other areas of your station read properly. There may be a problem with
your station.
La Crosse Technology, Ltd.
can cause loss of sensor signal. Avoid having more than 1 wall,
SENSOR DRAINS BATTERIES QUICKLY
FAHRENHEIT/CELSIUS
Page 4