Table of Contents
Advertisement
Available languages
Available languages
Dust extraction
Dust
extraction
accumulations
concentrations of dust in the ambient air
and facilitates disposal.
For long periods of working with wood or for
commercial use on materials that produce dust
that is detrimental to health, the machine is to be
connected to a suitable external dust extraction
device.
Unpacking
When unpacking, check to make sure that all
components are included. Refer to the drawings
on this manual. If any parts are missing or broken,
please call IVT assistance center.
Initial operation
Always use the correct supply voltage: the power
supply voltage must match the information quoted
on the tool identification plate.
Switching on and off
Before connecting the device to the electric power
supply, make sure that the main supply voltage is
230V/50Hz.
Switching on:
Press the on/off switch (2)
Switching off:
To switch the machine off, release the on/off switch
(2)
Operating instruction
•
Make sure that the workpiece is clamped
securely. Please be sure that the workpiece is
positioned face down, as the lower edge will be thus
processed more accurately.
•
The tool has to be switched off before saw blade
(6) touches the semi-finished piece. Do not apply
too much force; the operation has to last. Excessive
force applied will not accelerate the job, and will
result in the tool overload.
prevents
large
of
dust,
high
13
•
Hold the power tool with both hands by both
handles, as it will provide for the required control of
the tool.
•
Cut marks indicate the position of the cutting
blade (fig.3) while carrying out vertical cuts as, well
as cuts at 45°. It is advisable to carry out a trial cut to
eliminate errors in the course of the operation.
Setting the cutting depth
The power tool design enables the stepless cutting
depth adjustment. An accurate cut can be achieved,
if the cutting blade (6) overhangs the material by ca.
3 mm.
1.
Loosen the clamping screw of the cutting depth
ruler
2.
Set the desired cutting depth in accordance with
the reading on the cutting depth ruler scale
3.
Tighten the clamping screw of the cutting depth
ruler
Adjusting the cutting angle
The power tool design enables the stepless cutting
angle adjustment within the range from 0° to 45°.
1.
Loosen the clamping screws (8)
2.
Set the desired cutting angle in accordance with
the reading on the case inclination ruler scale
3.
Tighten the clamping screws (8) (fig.3)
fig.3
Cutting with the aid of the parallel stop
The parallel stop (7) enables cutting along the
existing straight edge of the workpiece, as well as
cutting the bars of equal width
1.
Loosen the clamping screw of the parallel stop
(7)
2.
Set the desired cutting width in accordance
with
the
reading
scale (7)
3.
Tighten the clamping screw of the parallel stop.
Manual instruction
on
the
parallel
stop
EN
Advertisement
Table of Contents
