Table of Contents
Advertisement
Receiving Data
After a successful connection setup, the receive characters that are arrive are stored in the
receive buffer. If two consecutive DLE codes are received, only one of these is stored in the
receive buffer.
After each receive character, the procedure waits out the character delay time for the next
character. If this period expires before another character is received, an NAK is sent to the
communication partner. The system program reports the error to the RECV_440 function
block (STATUS output parameter). The 3964(R) procedure does not initiate a repetition.
If transmission errors occur during receiving (lost character, frame error, parity error, etc.),
the procedure continues to receive until the connection is shut down, then an NAK is sent to
the communication partner. A repetition is then expected. If the undamaged block still cannot
be received after the number of transmission attempts defined in the static parameter set, or
if the communication partner does not start the repetition within a block wait time of 4
seconds, the procedure aborts the receive operation. The CP 440 reports the first failed
transmission and the final abortion of the receive operation to the RECV_440 function block
(STATUS output parameter).
Releasing a Receive Connection
When the 3964 procedure detects a DLE ETX character string, it ends the receiving
operation and confirms the successfully received block by sending a DLE signal to the
communication partner. When errors are found in the received data, it outputs a NAK signal
to the communication partner. A repetition is then expected.
If the 3964(R) procedure recognizes the string DLE ETX BCC, it stops receiving. It then
compares the received block check character with the longitudinal parity calculated
internally. If the BCC is correct and no other receive errors have occurred, the 3964(R)
procedure sends a DLE and returns to idle mode. If the BCC is faulty or a different receiving
error occurs, an NAK is sent to the communication partner. A repetition is then expected.
Point-to-point connection CP 440 Installation and Parameter Assignment
Manual, 09/2007, A5E00057742-03
www.gkbpx.com
Basic Principles of Serial Data Transmission
2.5 Data Transmission with the 3964(R) Procedure
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
49
Advertisement
Table of Contents
