Calibration Process (Tc3000 And Tc5000 Only) - Bowflex TreadClimber TC1000 Assembly And Owner's Manual

Assembly Guide
Step 19: CALIBRATION PROCESS (TC3000 and TC5000 only)
failure to calibrate your machine prior to use could result in machine failure
and could cause injury.
during the entire calibration process, stand on the side foot support platforms or rubber
mat only, do not stand on the walking belts!
DO NOT STEP ON THE BELTS DURING
THIS ENTIRE PROCESS.
Owners of the TC3000 or TC5000 will need to
calibrate the TreadClimber
can begin exercising. Owners of the TC1000 do not
need to complete this step.
Calibrating the TC3000 and TC5000 is an important
part of troubleshooting maintenance.
NOTE: You will also need to re-calibrate
your machine in the event of
a power outage or if you have
replaced a TreadClimber
component, such as a belt, or
motor.
19-1 Plug power cord into wall outlet.
19-2 Turn on Main Power Switch (see Figure 19-1).
19-3 Stand on the side foot support platforms or
rubber floor mat, DO NOT STAND ON THE
BELTS.
19-4 Insert the Safety Key, press and hold down the
POWER button, then very quickly press and
hold down the SLOWER button. Continue to
hold down the POWER and SLOWER buttons
(see Figure 19-2 for the TC5000 and Figure
19-3 for the TC3000).
NOTE: If the Safety Key is not fully
inserted into the safety keyhole, the
TreadClimber
power up.
19-5 At this point you should see the numbers start
to decrease on the console.
19-6 While continuing to hold down the POWER
and SLOWER buttons, remove and re-insert
the Safety Key.
Bowflex TreadClimber Owner's Manual
® ®
machine before they
®
®
machine will NOT
®
Figure 19-1
Main Power Switch "On"
Figure 19-2
TC5000 Power & Slower Buttons
Figure 19-3
TC3000 Power & Slower Buttons
24