Kia Cerato Owner's Manual page 37

6. Return the rear seat belt to the
proper position.
If the seat belt locks after unfolding
the rear seatback, pull out the locked
seat belt, release it then pull it out
again.
OYDDSA3042
• 5 door
1. Set the front seatback to the
upright position and if necessary,
slide the front seat forward.
2. Lower the rear headrests to lowest
position.
3. Pull the lock release lever (1) and
fold the rear seatback forward and
down firmly.
4. To use the rear seat, lift and pull the
seatback backward. Pull the seat-
back firmly until it clicks into place.
Make sure the seatback is locked in
place. When you return the seat-
back to its upright position, always
be sure it has locked into position by
pushing on the top of the seatback.
Safety features of your vehicle
If you can not see the red line at
the folding lever, it means the seat-
back is locked completely.
WARNING
After folding the rear seat,
unless the driver's position is
properly set according to the
driver's physical figure, do not
fold the rear seat. It may
increase body injuries in a sud-
den stop or collision.
WARNING -
Uprighting
seat
When you return the seatback
to its upright position, hold the
seatback and return it slowly. If
the seatback is returned with-
out holding it, the back of the
seat could spring forward
resulting in injury caused by
being struck by the seatback.
3 19