Kia Cerato Owner's Manual page 28

Safety features of your vehicle
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Vehicle speed is below 3 km/h and
the engine start/stop button is ON
or ignition switch ON.
2. Adjust the driver's seat comfort-
able for the driver.
3. Press SET button on the control
panel. The system will beep once.
4. Press one of the memory buttons
(1 or 2) within 5 seconds after
pressing the SET button. The sys-
tem will beep twice when memory
has been successfully stored.
3 10
Recalling positions from memory
1. Vehicle speed is below 3 km/h.
2. To recall the position in the memo-
ry, press the desired memory but-
ton (1 or 2). The system will beep
once, then the driver's seat will
automatically adjust to the stored
position.
Adjusting the control switch for the
driver's seat whilst the system is
recalling the stored position will
cause the movement to stop and
move in the direction that the control
switch is moved.
WARNING
Use caution when recalling the
adjustment memory whilst sit-
ting in the vehicle. Push the seat
position control switch to the
desired position immediately if
the seat moves too far in any
direction.
Easy access function
(if equipped)
The system will move the driver's
seat automatically as follows:
• Without smart key system
- It will move the driver's seat rear-
ward when the ignition key is
removed and front driver's door is
opened.
- It will move the driver's seat for-
ward when the ignition key is
inserted.
• With smart key system
- It will move the driver's seat rear-
ward when the engine start/stop
button is changed to the OFF
position and front driver's door is
opened.
- It will move the driver's seat for-
ward when you get in your vehicle
with the smart key after closing
the driver's door.
You can activate or deactivate this
feature. Refer to "User settings" in
chapter 4.