Kia Cerato Owner's Manual page 113

• Lock the doors by pressing the
lock button on the smart key.
After completion of the steps
above, the hazard warning lights
will operate once to indicate that
the system is armed.
If any door, trunk lid (tailgate) or
engine bonnet remains open, the
hazard warning lights won't oper-
ate and theft-alarm will not arm.
After this, if all doors, trunk lid
(tailgate) and engine bonnet are
closed, the hazard warning lights
blink once.
Using the transmitter
Park the vehicle and stop the engine.
Arm the system as described below.
1.Turn off the engine and remove the
ignition key from the ignition
switch.
2.Make sure that all doors, the
engine bonnet and trunk lid (tail-
gate) are closed and latched.
3.Lock the doors by pressing the lock
button on the transmitter.
After completion of the steps
above, the hazard warning lights
will blink once to indicate that the
system is armed.
If any door, trunk lid (tailgate) or
engine bonnet remains open, the
hazard warning lights won't oper-
ate and theft-alarm will not arm.
After this, if all doors, trunk lid (tail-
gate) and engine bonnet are
closed, the hazard warning lights
blink once.
Features of your vehicle
Do not arm the system until all
passengers have left the vehicle. If
the system is armed whilst a pas-
senger(s) remains in the vehicle,
the alarm may be activated when
the remaining passenger(s) leave
the vehicle. If any door, trunk (tail-
gate) or engine bonnet is opened
within 30 seconds after the sys-
tem enters the armed stage, the
system is disarmed to prevent
unnecessary alarm.
4 17