Philips 37PF9631D/37 Service Manual page 9

The new MkII aluminium stands (not on drawing) with order
code 3122 785 90690, can also be used to do measurements,
alignments, and duration tests. The stands can be
(dis)mounted quick and easy by means of sliding them in/out
the "mushrooms". The new stands are backwards compatible
with the earlier models.
Important: For (older) FTV sets without these "mushrooms", it
is obligatory to use the provided screws, otherwise it is possible
to damage the monitor inside!.
4.3 Assy/Panel Removal
4.3.1 Rear Cover
2
Figure 4-4 Rear cover lid removal
3
Figure 4-5 AmbiLight connector removal
Mechanical Instructions
1
G_15940_047.eps
240506
G_15940_048.eps
240506
EJ2.0U LA
5 5
5
5
5
2
1
1
5
5
5
5
5
5 5
Figure 4-6 Rear cover removal
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution: do not put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2. Remove the screws [1] that hold the rear cover lids and
remove the lids [2]. See figure "Rear cover lid removal" for
details.
3. Disconnect the connectors [3] behind the lids. See figure
"AmbiLight connector removal" for details.
4. Remove the mushrooms [4]. See figure "Rear cover
removal" for details.
5. Remove screws [5].
6. Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
4.3.2 Keyboard Control Panel
1. Remove the screws [1] that secure the panel. See figure
"Keyboard Control panel" for details.
2. Slide the bracket to the right.
3. Release clips [2].
4. Remove the panel.
5. Unplug connector [3].
When defective, replace the whole unit.
1
Figure 4-7 Keyboard Control panel (1)
4. EN 9
5 5
1 4
5
5 5
5 5
5
G_15940_049.eps
G_15940_050.eps
5
5
5
5
5
5
5
240506
240506