Table of Contents
Advertisement
SC-T3100x Series
User's Guide
Printable area
This section describes the printable areas for the printer.
If the print range settings in application software are
larger than the following printer printable areas,
sections beyond the specified margins are not printed.
Roll Paper
The gray area in the illustration below shows the
printable area.
The arrow in the illustration indicates the direction
that the paper is ejected.
*
In the printer driver Layout screen, selecting
Print Banner sets the top and bottom margins of
the paper to 0 mm.
Margins for roll paper depend on the settings values
for Top/Bottom Margins in the menu, as shown in
the table below.
Settings for Top/Bottom Margins
"Roll Paper menu" on page 106
U
The default setting is Standard.
Settings of Top/Bottom
Margins
Standard
Appendix
Margin Values
*
A,
C
= 30 mm
B,D
= 3 mm
158
Settings of Top/Bottom
Margins
Top 3 mm/Bottom 3 mm
Top 15 mm/Bottom 15 mm
Top 45 mm/Bottom 15 mm
3 mm
5 mm
*
If Standard is selected when the following two
conditions are met, then the top and bottom
margins will be 3 mm.
❏
The paper type settings are one of the following
Singleweight Matte, Coated Paper(Generic), Plain
paper, Plain Paper Thin, Plain Paper Thick, Tracing
Paper, Tracing Paper <LowDuty>, Matte Film
❏
The printer driver print targets are one of the
following
CAD/Line Drawing - Black, CAD/Line Drawing -
Color,CAD/Line Drawing - Bi-Level
c
Important:
❏ Printing is distorted when the trailing edge of
the roll paper comes off the core. Make sure
the trailing edge does not come inside the
printing area.
❏ If the print range settings width
than the print data width
sections beyond the printable width
not be printed.
Margin Values
A,C
= 3 mm
B,D
= 3 mm
A,C
= 15 mm
B,D
= 3 mm
A
= 45 mm
C
= 15 mm
B,D
= 3 mm
A,B,C,D
= 3 mm
A,B,C,D
= 5 mm
is smaller
, then the
will
Advertisement
Table of Contents
