Epson SC-T3100X Series User Manual page 119

SC-T3100x Series User's Guide
Settings item
Page Margin
Smoothing
Base Output Size
Using the Menu
Settings value
*
3 mm
5 mm
On
*
Off
*
Auto
A Series
US-ANSI
US-ARCH
B Series (ISO)
B Series (JIS)
Others
User-Defined
Explanation
Select the top, bottom, left, and right margin values.
For a cut sheet, the top, bottom, left, and right margin values are 3
mm regardless of the settings.
This setting is enabled when Resolution is set to Standard and
there is no resolution specification in the sent print data. Setting
this to On will print at the maximum resolution corresponding to
the Paper Type setting for the paper selected in Paper Source, but
depending on the data, this may result in a long print time, or
failures in printing because of insufficient memory.
The hard clip area of the PS command of the data becomes the
base output size. The actual output size depends on the Page
Margins option. When the data does not contain a PS command,
the smallest rectangle area
including the print object becomes the base output size.
The compatible standard sizes for the selected Paper Source are
displayed, therefore select the Base Output Size. The actual output
size depends on the Page Margins option.
For a cut sheet, this setting is available only when the data does
not contain a PS command. If the data contains a PS command, this
setting is not available, and the hard clip area of the PS command
becomes the Base Output Size.
Select this option when outputting at non-standard sizes. After
selecting this setting, set Paper Width and Paper Height. You can
set in 0.1 mm increments.
The actual output size depends on the Page Margins option.
119
of in the following illustration