Toro Lawn-Boy TimeCutter Z Series Service Manual page 67

11. To adjust the front-to-rear blade slope, remove the
locknuts and then rotate the adjustment nuts in the
front of the mower (Fig. A6 005).
A
B
Fig A6 005
A. Locknut and
adjusting nut
B. Front tire
12. To raise the front of the mower, tighten the adjust-
ment nuts. To lower the front of the mower, loosen
the adjustment nuts.
TimeCutter Z / Precision Z Service Manual
A
B
C
D
fi g. 45 G000546
C. Adjustment nut
D. Locknut
48" MOWER DECKS
13. After adjusting both adjustment nuts evenly, check
the front-to-rear slope again. Continue adjusting the
nuts until the front blade tip is 1/16" - 5/16" (1.6 -
7.9mm) lower than the rear blade tip (Fig. A6 005).
Note: After adjusting the adjustment nuts, make
sure there is no slack in either support rod
(Fig. A6 006). Tighten either one to remove
the slack (Fig. A6 005).
A B
Fig A6 006
A. Hairpin cotter and
clevis
14. When the front-to-rear blade slope is correct,
tighten the locknuts and check the side-to-side
level of the mower; refer to Leveling the Mower
from Side-to-Side.
fi g. 46 G000547
B. Support rod
A6-15
6