Toro Lawn-Boy TimeCutter Z Series Service Manual page 57

4. Remove the belt covers over the outside spindles.
5. Pull the idler pulley in the direction shown in
Figure 100 and roll the belt off of the pulleys.
CAUTION
The spring is under tension when installed and
can cause personal injury.
Be careful when removing the spring.
6. Route the new belt around the engine pulley and
mower pulleys (Figure 100).
7. Pull the idler pulley in the direction shown in
Figure 100 and route the belt onto the idler pulley
(Figure 100).
8. Rotate the belt guide, on the idler arm, so it is 1/32
to 1/8 inch (0.8–3mm) away from the side of the
mower belt (Figure 100).
TimeCutter Z Service Manual
38"/42" MOWER DECKS
9. Install the belt covers over the outside spindles.
Figure 100
(1) Mower belt (5) Engine pulley
(2) Idler arm (6) Belt cover
(3) Outside pulley (7) Belt guide
(4) Spring (8) 1/32 to 1/8 inch (0.8 - 3mm)
m-6428
6
6 - 5