Toro Lawn-Boy TimeCutter Z Series Service Manual page 61

4. Check and adjust the side-to-side blade level if
you have not checked the setting; refer to
"Leveling the Mower from Side-to-Side" on page 6
- 8.
5. Measure the length of the rod extending out of the
adjusting block on the sides of the chassis (Figure
105).
6. If the rod length is not a 3/4 inch (19 mm), remove
the hairpin cotter and washer from the end of the
adjusting rod (Figure 105) and turn the rod until
the 3/4 inch (19 mm) dimension is obtained.
7. Install the end of the rod into the hole in the mower
mount and secure it with the washer and hairpin
cotter. Repeat steps 5 through 7 for the opposite
side of the mower.
Figure 105
(1) Leveling bracket
(2) Adjusting block
8. Set the height-of-cut at position D [3 inch (76 mm)]
and carefully rotate the blades so they are facing
front to rear (Figure 106).
TimeCutter Z Service Manual
m-6432
(3) Adjusting rod
(4) Hairpin cotter and
washer
44" MOWER DECKS
9. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat
surface (Figure 106). If the front blade tip is not
1/16–5/16 inch (1.6–7.9 mm) lower than the rear
blade tip, adjust the front locknuts.
Figure 106
(1) Blades front to rear
(2) Outside cutting edges
10. To adjust the front-to-rear blade slope, remove the
locknuts and then rotate the adjustment nuts in the
front of the mower (Figure 107).
11. To raise the front of the mower, tighten the
adjustment nuts. To lower the front of the mower,
loosen the adjustment nuts.
m-7260
(3) Measure here
6
6 - 9