Maintenance And Troubleshooting - NordicTrack RW200 User Manual

Hide thumbs Also See for RW200:
Table of Contents

Advertisement

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
For best results, clean the rail, the seat carriage, and
the carriage rollers daily.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console displays become dim when batteries
are installed in the console, see assembly step 8 on
page 9.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the
resistance handle and the right and left shields as
described below.
First, remove the
six M4 x 10mm
Screws (70)
and then gen-
70
tly remove the
Resistance
Handle (9).
9
70
See EXPLODED DRAWING B on page 23. Locate
the Right and Left Shields (7, 8). Remove the four
M4 x 19mm Screws (69) and the ten M4 x 16mm
Screws (68) from the Right and Left Shields. Then,
gently remove the Right and Left Shields.
Next, locate the Reed Switch (47). Turn the Left Fan
(4) until a Magnet (85) is aligned with the Reed Switch.
Then, slightly loosen the two indicated M4 x 19mm
Screws (69), slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screws.
47
85
69
Turn the Left Fan (4) so that the Magnet (85) passes
the Reed Switch (47) repeatedly. Repeat these actions
until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
18
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntrw59147.1

Table of Contents