Step 1: Powering On The Appliance - Juniper JATP700 How To Set Up

Hide thumbs Also See for JATP700:

Table of Contents

Initial Configuration Process

Connecting the

Powering On

Management

the Device

Device

Step 1: Powering On the Appliance

CAUTION:

Before connecting the appliance to the power supply, attach an ESD strap to an ESD point and place the

other end of the strap around your bare wrist.

Plug the power cord into the AC receptacle on the rear panel.

If your appliance contains two power supplies, plug a power cord into each of the AC receptacle.

NOTE:

Grounding for the appliances is provided through the power supply ground terminal. Ensure that you

connect the AC power supply module in the appliance to a grounded AC power outlet by using an AC power cord

(with the grounding pin) appropriate for your geographical location.

Plug the other end of the power cord into a wall socket.

Press the Power button on the front panel.

Note the following indications:

Power button

Reset button

LEDs

Power

GLAN2

Alert/Power fail

Configuring a

Verifying the

JATP700

Settings

Appliance

HDD

GLAN1

Information

How to Set Up Your JATP700 Appliance

Table of Contents