Juniper JATP700 How To Set Up page 5

Type Yes to accept the agreement, and then press
4.
Enter a new CLI admin password to change the default password and then press Enter.
5.
NOTE: The password must be at least eight characters long.
Reenter the new password and then press Enter.
6.
Juniper Networks Advanced Threat Prevention window appears.
NOTE: By default, the JATP700 appliance is shipped with the All-In-One configuration. You can change the
configuration to your desired form factor by following the instructions from Step
Type Yes if you want to change the appliance form factor.
7.
NOTE: If you type No, then:
a. Type Yes to confirm that you do not want to change the appliance form factor.
b. Proceed to Step 10.
Enter a number from 1-4 to choose your desired form factor. For example, enter 2 to change the All-In-One to Traffic Collector
8.
form factor.
Type Yes to reconfirm to change the current form factor of the appliance.
9.
Services are restarted and a successful confirmation message displays about the change of the form factor.
Type Yes to configure the system by using the configuration wizard.
10.
Copyright © 2018, Juniper Networks, Inc.
.
Enter
How to Set Up Your JATP700 Appliance
7 to Step 10.
5