Juniper JSA7800 How To Set Up page 4

Hide thumbs Also See for JSA7800:

Table of Contents

How to Set Up Your JSA7800 Appliance

LED

Alert/Power Fail

Step 2: Connecting the Management Device

You can connect external devices using the ports on the back panel of the appliance.

If you use a laptop, connect the laptop to the DB-9 serial COM port on the back panel.

NOTE:

When using a laptop to connect to the appliance, you must use a terminal program, such as HyperTerminal,

to connect to the appliance.

NOTE:

If your laptop or PC does not have a DB-9 male connector pin and you want to connect your laptop or PC

directly to the JSA7800 appliance, use a combination of a USB to DB-9 male adapter and a DB-9 F/F cable.

Select the appropriate COM port to use.

Configure the following COM port settings:

Bits per second = 9600

Stop bits =1

Data bits = 8

Parity = None

Step 3: Configuring a JSA7800 Appliance

At the console prompt, log in as

NOTE:

The username is case sensitive.

Press

. The End User License Agreement (EULA) appears.

Enter

State

Solid red— Indicates a power supply failure.

Amber— Indicates that the appliance is operating normally.

(default username). No password is required when you log in for the first time.

root

Table of Contents