Charging Screen - Siemens SIJECT 16i Operation Manual

3.2.5 Charging screen

Operating sequences
SIJECT 16i Operation Manual
Fig 3-38 Charging screen
Press the Charging key to enter the charging screen. See Fig 3-38.
Four charging statuses are provided on the screen, and related parameters
can be set here, including position, pressure and flow. In addition,
backpressure can be selected to set the pressure.
Pre-decompression
the position, pressure and flow can be set here.
Charging 1 set the position, pressure and flow for charging 1. If
proportional backpressure valve is used, then the value should be set as
backpressure.
Charging 2 set the position, pressure and flow for charging 2. If
proportional backpressure valve is used, then the value should be set as
backpressure.
Charging 3 set the position, pressure and flow for charging 3. If
proportional backpressure valve is used, then the value should be set as
backpressure.
Charging 4 set the position, pressure and flow for charging 4. If
proportional backpressure valve is used, then the value should be set as
backpressure.
Decompression (Dec)
the position, pressure and flow can be set here.
Back pressure selection (BP Select)
backpressure valve or deselect it.
Screw position (ScwPos)
Screw rotation speed (ScwRmp)
speed.
In manual mode, press charging key
the key , and the charging will stop.
implement decompression before charging, and
implement decompression after charging, and
you can select the proportional
display the current position of screw.
display the actual screw rotation
to begin charging. Release the
SIJECT OP15B Screens
3-45