Fault In The Autodos (Automatic Dispensing) - Miele G 7960 C SCVi Operating Instructions Manual

Problem solving guide

Fault in the AutoDos (automatic dispensing)

Problem
The message
Insert PowerDisk or
deactivate AutoDos with OK
appears in the display.
The optical in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
The programme does
not start or a
programme that has
already started stops.
The message AutoDos lid
appears in the
open
display
The message
PowerDisk empty.
Deactivate AutoDos with
OK. appears in the
display.
The message
PowerDisk empty.
Deactivate AutoDos with
OK. appears in the
display even though you
have inserted a new
PowerDisk.
102
Cause and remedy
The AutoDos function is active but no PowerDisk has
been inserted.
 Insert a PowerDisk (see the "Detergent" chapter,
"Automatic dispensing/AutoDos" section).
 If you do not wish to use automatic dispensing,
deactivate the function using OK.
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see
"Detergent" chapter, "Automatic dispensing/
AutoDos" section).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Detergent"
chapter, "Inserting a PowerDisk" section).
 If the same fault message appears again, call the
Miele Customer Service Department.
The AutoDos function is active and the PowerDisk is
empty.
 Replace the PowerDisk (see the "Detergent"
chapter, "Automatic dispensing/AutoDos" section).
If you do not wish to use automatic dispensing,
deactivate the function using OK.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not
recognised the new PowerDisk.
 Switch the dishwasher on before replacing the
PowerDisk (see the "Detergent" chapter,
"Automatic dispensing/AutoDos", "Inserting a
PowerDisk" section).