Fault In The Autodos (Automatic Dispensing) - Miele G 7561 Operating Instructions Manual

Frequently asked questions

Fault in the AutoDos (automatic dispensing)

Problem
The following message
appears on the display:
Insert PowerDisk or deacti-
vate AutoDos with OK
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
The program does not
start or a program that
has already started
stops.
The following message
appears on the display:
AutoDos lid open
The following message
appears on the display:
PowerDisk empty. Deacti-
vate AutoDos with OK.
The message
PowerDisk empty. Deacti-
vate AutoDos with OK.
pears in the display
even though you have
inserted a new Pow-
erDisk.
100
Possible cause and solution
The  AutoDos function is active but no PowerDisk
has been inserted.
 Insert a PowerDisk (see "Automatic dispensing/
AutoDos" under "Detergent").
 If you do not wish to use AutoDos, deactivate the
function using OK or the  AutoDos sensor but-
ton.
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see "Auto-
matic dispensing/AutoDos" under "Detergent").
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Inserting a
PowerDisk" under "Detergent").
 If the same fault message appears again, contact
Miele Technical Service.
The  AutoDos function is active and the PowerDisk
is empty.
 Replace the PowerDisk (see "Automatic dispens-
ing/AutoDos" under "Detergent").
If you do not wish to use AutoDos, deactivate the
function using OK or the  AutoDos sensor but-
ton.
The dishwasher was turned off when the PowerDisk
was replaced and it has therefore not recognized the
ap- new PowerDisk.
 Turn the dishwasher on before replacing the Pow-
erDisk (see "Automatic dispensing/AutoDos" and
"Inserting a PowerDisk" under "Detergent").