Table of Contents
Advertisement
Problem solving guide
Fault in the AutoDos (automatic dispensing)
Problem
The following message
will appear on the dis-
play:
Insert PowerDisk or deactiv-
ate AutoDos with OK
The optical in-operation
indicator light is flash-
ing quickly.
The alarm tone is
sounding.
The programme does
not start or a pro-
gramme that has
already started stops.
The message
AutoDos lid
open
appears in the dis-
play
The following message
will appear on the dis-
play:
PowerDisk empty Deactiv-
ate AutoDos with OK
The message
PowerDisk empty Deactiv-
ate AutoDos with OK
pears in the display
even though you have
inserted a new
PowerDisk.
96
Cause and remedy
The AutoDos function is active but no PowerDisk
has been inserted.
Insert a PowerDisk (see "Detergent – Automatic
dispensing/AutoDos").
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dos button.
The AutoDos lid has not been closed properly.
Close the AutoDos lid and lock it fully (see "Deter-
gent" chapter, "Automatic dispensing/AutoDos"
section).
If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Detergent"
chapter, "Inserting a PowerDisk" section).
If the same fault message appears again, call the
Miele Customer Service Department.
The AutoDos function is active and the PowerDisk
is empty.
Replace the PowerDisk (see "Detergent – Auto-
matic dispensing/AutoDos").
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dos button.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not re-
ap-
cognised the new PowerDisk.
Switch the dishwasher on before replacing the
PowerDisk (see the "Detergent" chapter, "Auto-
matic dispensing/AutoDos", "Inserting a
PowerDisk" section).
Advertisement
Table of Contents
