Table of Contents
Advertisement
Operation
End of programme
At the end of a programme, the optical
in-operation indicator light will flash
slowly with the door shut. The buzzer
might also sound.
The optical in-operation indicator light
will go out 10 minutes after the end of
the programme if the door is closed.
The programme has ended when the
display shows the message
In some programmes, if the AutoOpen
function is activated, the door will
automatically open slightly (see
"Settings – AutoOpen"). This improves
the drying process.
If the
Consumption
function is switched on, you can now
call up the actual energy and water
consumption of the programme that
has just finished (see "Caring for the
environment – EcoFeedback
consumption indicator").
The drying fan may continue to run for
a few minutes at the end of the
programme.
Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of delicate
worktops when you open the door at
the end of the programme if the fan
is no longer running.
If you have deactivated the
automatic door opening function (see
"Settings – AutoOpen"), but would
still like to open the door at the end
of the programme, then make sure
that you open the door fully.
70
Finished
programmable
Energy management
To save energy the dishwasher will
switch off automatically 10 minutes
after the last time a sensor control is
pressed or after the end of a
programme.
You can switch the dishwasher back on
again with the sensor control.
If the dishwasher has been switched off
.
for longer than 1 minute, you will need
to hold the sensor control for a bit
longer (wipe protection).
The dishwasher will not switch itself
off whilst a programme is running or if
there is a fault.
Advertisement
Table of Contents
