Building In - Zanussi ZGF 643 Instruction Booklet

7. Building In

A = Auxiliary burner
R = Rapid Burner
These hobs can be inserted in a built-in kitchen unit
whose depth is between 550 and 600 mm. The hobs
dimensions are shown in Fig. 9.
FITTING THE LID
We recommend the lid hinge block are fitted before
installing the hob into the worktop.
To install the lid onto the hob, proceed as follows:
a. Remove the right and left hand grid blocks fitted to
the back of the hob, by unscrewing the relevant
screws (fig. 10)
b. Fit the lid hinge blocks onto the hob, using the
original screws, ensuring that the relevant shims are
fitted between the hinge blocks and the hob (fig. 10);
c. Fit the left hand lid hinge (marked S) into the hinge
block (fig.11);
d. Carry out the same operation with the right hand lid
hinge (marked D).
ADJUSTING THE LID BALANCE
To adjust the lid balance, turn clockwise or anti-
clockwise the central screw of the right- and left-hand
hinges (fig. 12).
SR = Semirapid burner
SR
A
FO 2035
FO 2036
Fig. 11
SR
R
Fig. 9
Fig. 10
FO 2037
Fig. 12
39