Building In - Zanussi ZGF 646 CT User Manual

Building in

SR
A
A = Auxiliary burner
SR= Semi-rapid burner
R = Rapid burner
This hob can be inserted in a built-in
kitchen unit whose depth is between
550 and 600 mm. The hobs dimensions
are shown in Fig. 4.
The edge of the cut out must have a
minimum distance from the rear wall of
55 mm.
If there are side walls, or sides of the
furniture unit near the hob, the cut out
edges must have a minimum distance of
100 mm.
Hanging forniture units or hoods
must be placed at 650 mm. minimum
from the hob.
Fitting the lid
We recommend the lid hinge block We recommend the lid hinge block
We recommend the lid hinge block We recommend the lid hinge block We recommend the lid hinge block
are fitted before installing the hob are fitted before installing the hob are fitted before installing the hob
are fitted before installing the hob are fitted before installing the hob
into the worktop. into the worktop. into the worktop.
into the worktop. into the worktop.
To install the lid onto the hob, proceed
as follows:
a. a. a. a. a. Remove the right and left hand grid
blocks fitted to the back of the hob, by
unscrewing the relevant screws (Fig.
5).
SR
R
Fig. 4
SR
A
R
SR
Fig. 5
17