Camera; Installer Menu - Bosch MIC IP ultra 7100i User Manual

MIC IP ultra 7100i │ MIC IP starlight 7100i
5

Camera

5.1

Installer Menu

Application variant
–
–
Sensor mode
The sensor mode specifies the base resolution and frame rates for the image quality settings.
Fast moving scenes use more frame rates (50 fps or 60 fps) for better image quality than slow
moving scenes. Adjust this setting as necessary.
This higher resolution (HD 1080p) gives maximum detail in these scenes, but can result in
motion artifacts for fast-moving objects because of the lower frame rates.
Some types of light can show flickering in the image when the frame rate is not synchronized
with the mains power frequency. To avoid this, the sensor mode frame rate should be in line
with the power frequency:
–
–
Select On to output a mirror image of the camera picture.
Note: Privacy masks are not supported in mirror image mode.
Coding standard
Select the encoding mode:
–
–
–
H.265 (no B-frames) is a restrictive mode for the encoder where it only supports I and P
frames. This decreases calculation power so that there can be a higher frame rate (for
example, 30 fps for a camera that might be restricted to 25 fps).
Orientation
The orientation of the camera. Options: Normal, Inverted, Canted.
SC settings
Click the Default button to restore all camera settings to their original defaults.
Reboot device
Click the Reboot button to reboot the camera. There is a ten (10) second pause before the
camera starts its homing phase. During the homing phase, the camera will complete finding
the upper and lower tilt limits.
Factory defaults
Click Defaults to restore the factory defaults for the camera. A confirmation screen appears.
Allow several seconds for the camera to optimize the picture after a reset.
Note: Clicking this button also clears the service-level password. Operators must reset the
password before doing anything else.
Caution!
Do not remove power to the unit during a factory default or a firmware update. Wait at least
!
two minutes for the default process to complete. If the unit appears to be "frozen" after two
minutes, then reboot the unit. Refer to Troubleshooting, page 74 for more details.
Bosch Security Systems
If you are connecting to MIC-ALM-WAS-24, select "[camera name] - IO" to allow the
camera to recognize additional inputs and outputs from this device and to allow control
of an external washer unit.
Otherwise, select "[camera name]."
50Hz: 25 or 50 fps
60Hz: 30 or 60 fps
H.264
H.265
H.265 (no B-frames)
User Manual
Camera | en 19
2020-11 | 1.4 |