Table of Contents
Advertisement
all-UX84H.book Page 47 Wednesday, July 5, 2000 8:48 AM
Downloaded from:
http://www.usersmanualguide.com/
Transfer Function
The Transfer function is used to make the UX-84 automatically call
you at a specified number every time it receives an incoming
message. This lets you hear your messages immediately after they
come in, even when you are at a remote location.
When you answer the telephone, you will hear your recorded message
telling you that the call is a transfer call. Enter "#", your remote code
number, and "#". The answering machine will then play back your
messages. You can also perform any of the remote operations
described in Remote Operations later in this chapter.
Note: When you hang up after a transfer call, the UX-84 will not imme-
diately resume normal operation. If you want the UX-84 to accept calls
immediately after a transfer call, enter "*" twice before hanging up (if
you want to hang up during message playback, first enter " 0" and " #" to
stop playback, then enter "*" twice).
Programming the transfer number
To use the Transfer function, you must first give the UX-84 the
number to call (the transfer number). This is done by pressing the
panel keys as follows:
1
Press these keys:
The display will show:
A.M. SETTINGS
2
Press these keys:
The display will show:
TRANSFER # ENTRY
Transfer Function
FUNCTION
0
47
Advertisement
Table of Contents
