Fastening The Front Panel; Removing The Unit - Pioneer Supertuner IIID DEH-1200MP Owner's Manual

Section
(~ln_s_t_a_lI_a_ti_o_n
)
CD
2 Tighten two screws on each side.
• Use either truss (5 mm x 8 mm) or flush
surface (5 mm x 9 mm) screws, depending
on the bracket screw holes.
~
_.
en
=r
m
:::J
(Q
Screw
Fastening the front panel
If you do not plan to detach the front panel,
the front panel can be fas ened with the sup-
plied screw.
Dashboard or console ounting bracket
Screw
Removing the unit
1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with the groove down.)
Trim ring
• Releasing the front panel allows easier ac-
cess to the trim ring.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
En
(ill