Table of Contents
Advertisement
10. Close the SMP Expansion Module top cover; then, install the module in the
11. If you have other options to install or remove, do so now.
12. Close the cover on the server; then, reinstall the server in the rack cabinet and
13. Turn on the server.
22
Installation Guide
Captive screws
Protective cover
b. Align the heat sink over the microprocessor; then, carefully set it down on top
of the microprocessor.
c. Using a screwdriver, secure the heat sink to the microprocessor socket on the
SMP board using the two captive mounting screws. Press firmly on the
screws and tighten them, alternating between them. Do not overtighten the
screws.
server. For details, see "Reinstalling an SMP Expansion Module and cover" on
page 26.
connect all external cables. For details, see "Completing the installation" on page
29.
Important: If your server will not start after replacing or installing a microproces-
sor, you might have installed a microprocessor of a different type or the VRM is
not installed properly. Verify that you have installed the proper microprocessor and
that the VRM is properly installed.
Note: When you install or remove microprocessors, the server configuration
information changes. Therefore, you must change and save the new con-
figuration information by using the Configuration/Setup Utility program.
Heat sink
Advertisement
Table of Contents
