Installation - Dometic Milenco Aero DM-1899 Installation Instructions Manual

INSTALLATION

A. Mirror Assembly
1.  A ssemble mirror head to arm.
a. Using a #2 Phillips screwdriver, remove truss
head screw (4 mm x 28 mm) from mirror
head ball socket. See (FIG. 2).
FIG. 2
Screw
(4 mm x 28 mm)
b. Slide short end of arm into hole in mirror
head ball socket, aligning cross hole in arm
with screw hole in mirror head ball socket.
Select desired arm position (right hand, left
hand, etc.). See (FIG. 3).
FIG. 3
Right Hand, Above
Right Hand, Below
 N OTE: To change from right hand to
left hand, and left hand to right hand,
rotate arm in ball socket 180º.
c. Assemble screw to mirror head ball socket
and hand tighten with a #2 Phillips screw-
driver, securing mirror head to arm. See
(FIG. 4).
Mirror Head
(PN DM-1984)
Left Hand, Above
Left Hand, Below
FIG. 4
2. Repeat steps (a) through (c) for other mirror.
B. Mirror Installation
The aero wide towing mirror can be mounted above
or below the vehicle mirror, whichever works best
for your situation. On certain vehicles, it may only
fit above or below the vehicle mirror. See (FIG. 3).
1.  L oosen thumb screws ("2" on thumb screw),
and remove mirror clamps from slide arm. See
(FIG. 5).
FIG. 5
"2"
2. Loosen thumb screws ("1" on thumb screw).
See (FIG. 5).
3. Assemble (2) mirror clamps to vehicle mirror,
sliding "foot" of clamps between vehicle mirror
and vehicle mirror housing. See (FIG. 6).
 S lide clamps in as far as possible for max-
imum clamp contact.
3
"1"
Mirror Clamp
(PN DM-1960)