Daily Shutdown - Graco Fusion AP Instructions Manual

Daily Shutdown

Grease your gun daily to prevent two component curing
and keep fluid passages clean. Purge air carries grease
mist through the air chamber (AC) and impingement
ports (IP) and out the mix chamber nozzle (N), coating
all interior surfaces.
Key
Purge Air
Fluid
Cleanoff Air
Grease
G
19
309550ZAP
1. Follow the Pressure Relief Procedure, page 19.
2. Leave the air turned on and gun detriggered.
3. Remove the grease fitting cap. Using the grease
gun (Y), dispense grease into fitting (G) until grease
mist sprays from mix chamber nozzle (N).
NOTE: Do not over-grease. Use two shots maximum.
Do not spray grease mist on sprayed material.
4. Replace the grease cap.
5. Round and flat pattern guns only: Turn off the air
AC
valve (W).
Spatter pattern gun only: Shut down the main air
IP
supply.
N
Y
G
N
TI2415A
Operation
W
21