Preparing The Dab Tuning - Yamaha TX-761DAB Owner's Manual

Preparing the DAB tuning

Before tuning into DAB services, you must perform the
automatic scanning.
DIMMER AUTO SCAN MEMORY
STANDBY
/ON
AUTO SCAN
1
4
7
0
ENTER
Press BAND on the front panel (or remote
control) repeatedly to select DAB as the
reception band.
The DAB indicator lights up in the front panel display, and
then "DAB initialize" appears in the front panel display.
When you select DAB as the reception band for the first
time, the following message appears for 2 second.
DAB initialize
Please wait
This unit starts scanning for DAB services in the area and
add them to the channel list as they are found.
Autoscan Full
>
The number of channels found is displayed. The number is
updates when new channels are found.
Autoscan Full 10
>>>>>>>>>>>
Once the scanning is complete, this unit is tuned into the
DAB service of the DAB service registry list.
PRESET/TUNING
BAND INFO/TEXT FUNCTION SELECT
DAB/FM/AM FM MODE TUNING MODE
BAND
POWER
BAND
DAB/FM/AM
2 3 BAND
INFO/TEXT
5 6
AUTO SCAN
AUTO SCAN
8 9
MEMORY
CLEAR
0
DAB (Digital Audio Broadcasting) tuning
y
When you have already performed the automatic scanning before
you set this unit to the DAB tuning mode for the first time, "DAB
initialize" does not appear in the front panel display. See step 2 on
page 12, and proceed with the DAB tuning operation.
If the automatic scanning operation is not
successful...
"No stations Available" and then following display
appears in the front panel display.
< > or select
pTune aid
Rotate PRESET/TUNING (or press SELECT
repeatedly) to select "Tune aid" or "Autoscan".
• Select "Tune aid" to check the signal strength of the
DAB channel that is broadcast from the nearest
station (see page 14).
• Select "Autoscan" to carry out the automatic
scanning operation again.
For further details about problems and their remedies,
refer to the "Tuner" section in "Troubleshooting" on
page 25.
■ Using the automatic scanning function
Use the automatic scanning function to scan the DAB
service again. This feature is useful when you want to
register new DAB services or you want to register the
DAB services broadcast in another location.
You can select the scanning frequency range as follows.
Full range scanning
This unit scans the entire range of Band III and L Band
(see page 18).
Press and hold AUTO SCAN on the front panel
(or remote control) for 3 seconds.
This unit starts the full range scanning. "Autoscan Full"
appears in the front panel display.
Once this unit has finished scanning, this unit is tuned into
the first DAB station in the DAB service registry list.
Local range scanning
This unit scans the limited range of Band III.
Press AUTO SCAN on the front panel (or remote
control) briefly.
This unit starts the local range scanning. "Autoscan
Local" appears in the front panel display.
Once this unit has finished scanning, this unit is tuned into
the first DAB station in the DAB service registry list.
Note
If this unit cannot detect a DAB service in the DAB service
registry list when this unit performs the automatic scanning
operation, this unit deletes the service.
[
11
En