Table of Contents
Advertisement
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
AUTOMATIC TUNING
1
1
POWER
2
Select the reception band (FM or AM) while watching
the display.
FM/AM
3
TUNING MODE
AUTO/MAN'L
4
For FM reception, set the MODE, BLEND and IF MODE
buttons as desired. (Refer to page 8 for details.)
Display information
FM
TUNING OPERATIONS
4
2 3
or
AM
FM
STEREO
WIDE
0
50
100
AUTO TUNING
STEREO
MHz
WIDE
0
50
100
AUTO TUNING
5
Tune to a desired station.
TUNING
To tune to a higher frequency, slightly turn the control
to the right. To tune to a lower frequency, slightly turn
the control to the left.
6
If the station where tuning search stopped is not the
desired one, turn again.
TUNING
* If the tuning search does not stop at the desired
station, change to the MANUAL TUNING method as
described on the following page.
Displays the band and frequency of the received station.
* If an RDS station is received, the frequency is then
replaced by the station name. (However, if the PS data
cannot be received within 5 seconds, "NO PS" flashes,
and then it returns to the frequency display.)
Refer to page 14 for details.
Illuminates when an FM stereo broadcast is received in
stereo.
Indicates the signal level of the received station.
5, 6
7
Advertisement
Table of Contents
