Recording A Source To Audio/Video Tape (Or Dubbing From A Tape To Another) - Yamaha DSP-A3090 Operation Manual

RECORDING A SOURCE TO AUDIO/VIDEO TAPE (OR DUBBING FROM A TAPE TO
ANOTHER)
1. Set the REC OUT selector to the SOURCE position.
2. Select the source you want to record.
Front panel
INPUT SELECTOR
LD
TV/DBS TAPE 1
VCR 1 TUNER
VCR 2
VCR 3/DVD
PHONO
VIDEO AUX
3. Play the source and increase the setting of the master VOLUME
control to confirm it.
4. Set the tape deck or VCR used for recording to the recording
mode.
48
Front panel
REC OUT
SOURCE TAPE 1
LD CD
TV/DBS
VCR 1
VCR 2
VCR 3/DVD
VIDEO AUX
Remote control
CD
or
CD
Front panel
VOLUME
Regardless of the setting of the INPUT SELECTOR, when you
set the REC OUT selector to CD, the audio signal from your CD
player can be recorded by your first tape deck. Likewise, when the
REC OUT selector is set to LD, TV/DBS, VCR 2, VCR 3/DVD or
VIDEO AUX, both the audio and video signals of the selected source
can be recorded by your first VCR.
While recording a source by setting the REC OUT selector to the
position other than SOURCE as described above, the following
operations can be made at the same time.
You can monitor the audio (or the audio and video) signals being
recorded by selecting TAPE 1 (or VCR 1) on the INPUT
SELECTOR.
You can watch or listen to any other source by selecting it with the
INPUT SELECTOR.
You can use any other VCR or tape deck not selected by the REC
OUT selector to record an audio and video source selected by the
INPUT SELECTOR.
The audio and video signals from VCR 2 (or VCR 3) are sent to
VCR 1 when the REC OUT selector is set to VCR 2 (or VCR 3).
If the REC OUT selector is set to VCR 2 (or VCR 3), you can not
dub from your first VCR to the second VCR (or the third VCR), even if
VCR 1 is selected by the INPUT SELECTOR.
To dub the audio from your second tape deck to the first one,
depress the TAPE 2 MONITOR switch (and set the INPUT
SELECTOR to any source other than TAPE 1 before beginning to
record).