Recording A Source To Audio/Video Tape (Or Dubbing From A Tape To Another) - Yamaha DSP-A990 Operation Manual

2-2. RECORDING A SOURCE TO AUDIO/VIDEO TAPE
(OR DUBBING FROM A TAPE TO ANOTHER)
To record the input source
1. Press the REC OUT switch (so that "REC OUT ... " appears on the
display and the monitor screen).
Front panel
2. Within 5 seconds, select the "SOURCE" position with the input
selector switch (so that "REC OUT SOURCE" appears on the
display panel and the monitor screen).
Front panel
INPUT SELECTOR
REC OUT SOURCE
VCR I CD LD
3. Press the REC OUT switch (so that "REC OUT SOURCE"
disappears from the display).
* The same result will be obtained after 5 seconds without any
operation.
4. Select an input source to be played (and to be recorded).
(See page 28 for the method of input source selection.)
Front panel
INPUT SELECTOR VCR I CD
TV/DBS
PHONO
5. Play the source.
6. Set the tape deck or VCR used for recording to the recording
mode.
* Adjust the recording level on the tape deck or VCR.
NOTE: To record picture from a video source and sound from
another audio source, in step 4, first select a video source with an
input selector switch on the front panel, and then select an audio
source with the input selector keys on the remote control unit.
Remote Control
LD
CD
or
29