2-2.Recording A Source To Audio/Video Tape; (Or Dubbing From A Tape To Another) - Yamaha DSP-A970 Operation Manual

2-2. RECORDING A SOURCE TO AUDIO/VIDEO TAPE

(OR DUBBING FROM A TAPE TO ANOTHER)

To record an input source to be played
1. Press the REC OUT switch (so that "REC OUT ... " appears on the
display and the monitor screen).
2. Within 5 seconds after the REC OUT switch is pressed, select the
"SOURCE" position with the input selector switch (so that "REC
OUT SOURCE" appears on the display panel and the monitor
screen).
28
Front panel
Front panel
3. Press the REC OUT switch (so that the indicator corresponding
to the selected source to be recorded stops flashing).
* The same result will be gained after 5 seconds automatically
without any operation.
4. Select an input source to be played (and to be recorded).
(See page 27 for the method of input source selection.)
Front panel
5. Play the source.
6. Set the tape deck or VCR used for recording to the recording
mode.
* Adjust the recording level on the tape deck or VCR.
Remote control