All Channel Search Mode; Direct Number Access Mode; Category Search Mode; Preset Search Mode - Yamaha RX-V661 Owner's Manual

Before performing operations, set the operation mode selector
K
on the remote control to SOURCE.

■ All Channel Search mode

Press 2 SEARCH MODE (or N SRCH
1
MODE) repeatedly to select "ALL CH
SEARCH".
Press 5 PRESET/TUNING/CH l / h (or
2
D PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and
5
PRESET/TUNING/CH l / h (or
holding
D
PRESET/CH k / n).
• To display the XM Radio ID number displayed in the front
panel display, select channel "0".

■ Category Search mode

Press 2 SEARCH MODE (or N SRCH
1
MODE) repeatedly to select "CAT SEARCH".
Press 4 CATEGORY (or D A-E/CAT. l / h)
2
repeatedly to change the channel category.
Press 5 PRESET/TUNING/CH l / h (or
3
D PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and
holding 5 PRESET/TUNING/CH l / h on the front
panel (or D PRESET/CH k / n on the remote control).

■ Preset Search mode

Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see "Setting the XM Satellite Radio preset
channels" on page 56.
y
The initial factory setting of all preset channels (A1 to E8) is
"[001] Preview".
Press 2 SEARCH MODE (or N SRCH
1
MODE) repeatedly to select "PRESET
SEARCH".
Press 4 CATEGORY (or D A-E/CAT. l / h)
2
repeatedly to change the preset channel
group (A to E).
Press 5 PRESET/TUNING/CH l / h (or
3
D PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (

■ Direct number access mode

Press N SRCH MODE on the remote control
1
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH".
2
Press the numeric buttons ( B ) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons ( B ) as shown below.
CLASSICAL
LIVE/CLUB
1
The display changes as follows.
<XM> --1
<XM> -12
<XM>123
y
• To enter a one-digit or two-digit channel number, press the
numeric buttons ( B ) on the remote control and then press
M ENT to confirm the input number.
• Instead of pressing M ENT to tune into the channel
immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• If no button is pressed within a few seconds after you enter
a one-digit or two-digit number, this unit automatically
confirms the entered channel number.
• Pressing a button other than the numeric buttons ( B ) or
M ENT cancels the Direct Number Access mode
procedure.
XM Satellite Radio tuning
B
).
ENTERTAIN
3
2
55
En