All Channel Search Mode - Yamaha RX-V1900BL Owner's Manual

■ All Channel Search mode

Press ISEARCH MODE (or HSRCH
1
MODE) repeatedly to select "ALL CH
SEARCH".
2
Press GPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
GPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
• You can skip channels to the previous or next category by
pressing KCATEGORY (or 8A-E/CAT. l / h).
■ Category Search mode
Press ISEARCH MODE (or HSRCH
1
MODE) repeatedly to select "CAT SEARCH".
2
Press KCATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the channel category.
3
Press GPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
GPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
Note
This unit skips the channels when this unit is in the All Channel
Search mode or Category Search mode in the following cases (it
is not malfunction of this unit):
– the channel is locked (page 61).
– the channel is out of service.
– you do not subscribe to the channel.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
"Setting the SIRIUS Satellite Radio™ preset channels"
(page 60).
Press ISEARCH MODE (or HSRCH
1
MODE) repeatedly to select "PRESET
SEARCH".
2
Press KCATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3
Press GPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (A).
■ Direct number access mode
Press HSRCH MODE on the remote control
1
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH".
2
Press the numeric buttons ( A ) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons ( A ) as shown below.
1
y
• To display the Sirius ID number displayed in the front panel
display, select channel "0".
• To enter a one-digit or two-digit channel number, press the
numeric buttons ( A ) on the remote control and then press
MENT to confirm the input number.
• Instead of pressing MENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
• If no button is pressed within a few seconds after you enter a
one-digit or two-digit number, this unit automatically confirms
the entered channel number.
• If the selected channel is locked, "PIN:___" appears in the front
panel display. Enter the four-digit Parental Lock code number
by using the numeric buttons ( A ) or press MENT to cancel
(page 61).
SIRIUS Satellite Radio™ tuning
2 3
59
En