Basic Operations - Yamaha DSP-A590 Owner's Manual

TO PLAY A SOURCE
1
Set to the "
2
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
TAPE
MONITOR TUNER
VIDEO AUX VCR 2
* The name of the selected input source will appear in
the display.
4
Select the front speakers to be used.
SPEAKERS
A
ON
OFF
* If you use two front speaker systems, press both the A and
B switches.

BASIC OPERATIONS

2
4
∞
" position.
POWER
CD PHONO
VCR 1 LD/TV
B
ON
OFF
7 3
7
5
Play the source.
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 17) and use the digital
sound field processor. (Refer to page 20.)
Notes on using the input selector buttons
Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
* To select the source connected to the VIDEO AUX
terminals on the front panel, press VIDEO AUX.
The selection of TAPE MONITOR cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE MONITOR again.
When you select a button other than TAPE MONITOR,
make sure that TAPE MONITOR is not also selected.
If you select the input selector button for a video source
without canceling the selection of TAPE MONITOR, the
playback result will be the video image from the video
source and the sound from the audio tape.
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
To turn off the power
Press the POWER switch again.
1, 6
15