Playback; Basic Operations - Yamaha DSP-AX463 Owner's Manual

PLAYBACK

Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.

Basic operations

1
Turn on the video monitor connected to this
unit.
Press E SPEAKERS repeatedly to select the
2
front speakers you want to use.
The respective speaker indicators lights up in the
front panel display.
Press J INPUT l / h repeatedly (or press
3
one of the input selector buttons ( 3 )) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
Available input sources
MULTI CH DVR V-AUX
USB
INPUT: DVD
Currently selected input
source
4
Start playback on the selected component.
Refer to the operating instructions for the source
component.
32
En
Playback
DTV/CBL DVD MD/CD-R CD TUNER
Rotate D VOLUME (or press
5
L VOLUME +/–) to adjust the volume to the
desired output level.
Press G PROGRAM l / h repeatedly (or
6
press 4 AMP and then A PROG l / h
repeatedly) to select the desired sound field
program.
The name of the selected sound field program appears
in the front panel display.
See page 37 for details about sound field programs.
Movie Dramatic
Currently selected
surround field program
Notes
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the
input source (see page 33).
• When PCM signals with a sampling frequency higher than 48
kHz are input, this unit is automatically set to the "STRAIGHT"
mode (see page 38).
• To display information about the currently selected input source
in the OSD, see page 35 for details.
■ A quick guide to contents
When you want to...
Enjoy high quality sound
Adjust the tonal quality of the front speakers
Adjust the parameters of sound field programs
Enjoy the sources with a wide dynamic range at night
Use headphones
Select a decoder to play back sources with
Automatically set this unit to the standby mode
See
page
40
40
39
41
34
38
36