Table of Contents
Advertisement
7. Adjust tractor drawbar (hitch) so mounting hole is less
than 50 inches from outside of rear tractor tire (Fig. 1).
This will prevent interference with front cutting unit lift
arms.
Note: If tractor drawbar cannot be adjusted as described
above, use caution when turning, to avoid contact.
Figure 1
Install Jack
1. Remove jack from storage position by removing pin
and sliding jack off storage tube (Fig. 2).
Figure 2
1. Pin
2. Raise front of frame and slide jack onto mounting tube
aligning mounting holes in jack with holes in mounting
tube. Secure with pin. (Fig. 3).
2. Storage tube
Figure 3
3. Jack frame to desired height, by rotating jack handle
clockwise to raise and counterclockwise to lower.
Adjust Hitch
1. Measure height from ground to top of hitch on tow
tractor.
2. Adjust transport frame hitch up or down according to
measurement of tractor hitch. Use appropriate mounting
holes as shown in chart below and in Fig. 4.
Tractor Hitch Height
Below 11"
11" to 15"
Above 15"
Figure 4
1. Hitch
2. Bottom mounting holes
9
Frame Mounting Holes
Bottom (2) sets of holes
Middle (2) sets of holes
Top (2) sets of holes
3. Middle mounting holes
4. Top mounting holes
Advertisement
Table of Contents
